Description

RQ3 Picket Driver Puller

When you use the driver with your cliff pickets you are extending their service life 10 to 1 compared to solid pickets.

We designed the puller to make installing picket systems as efficient and safe as possible. Weighing in at 11.2 pounds, we constructed the RQ3 Picket Driver from two-inch diameter, eighth-inch thick, drawn-over-mandrel steel tubing. The 18-inch body keeps the picket aligned with the direction of each drive stroke. This ensures every strike drives the stake deeper into the ground without wasting any energy to the sides.

We bent the driver handles at right angles and MIG welded them to the body. This welding technique allows for numerous different holds on the driver, maximizing user ergonomics and the force of each blow. The weighted end cap is two-and-a-half inches wide. We welded the end cap using the TIG method. This added weight in the cap end increases the force of each strike you deliver, reducing the overall number of strokes required to sink the stake. Ultimately, fewer strikes delivered along the full length of the picket, rather than off-angle strikes, extend the life of the stake an estimated ten times longer than a picket driven with a sledgehammer or post driver.

You must use the RQ3 Picket Driver Puller only with RQ3 pickets manufactured after February 2016. Other pickets may damage the Picket Driver/Puller head and void the warranty.