3-1-dual-wall-adhesive-lined-heat-shrink-tubing

3:1 Dual Wall (Adhesive Lined) Heat Shrink Tubing

PMI® Rope Pack

PMI Rope Pack

Elk River Ropeguard 2' x 4

Elk River ROPEGUARD 2'

3:1 Dual Wall (Adhesive Lined) Heat Shrink Tubing

Adhesive Lined Heat Shrink Tubing is a great way to keep rope identification attached to rope and not slide off during rope use. This 3/4" tubing will shrink down to a minimum size of 1/4".

As low as $1.80
Availability: In stock
Only %1 left
SKU
HS3A-075
BuyHeatShrink.com

This "dual-wall" construction, 3:1 heat shrink tubing combines shrink and adhesive materials. The outer wall is constructed utilizing Polyolefin heat shrink, while combining the effectiveness of an inner wall hot melt adhesive. Applying heat shrinks the inner layer enabling the adhesive to flow and create a protective, water-tight seal.


Features:

  • 3:1 Shrink Ratio (1/3 original diameter)
  • Longitudinal shrinkage of up to 15% possible
  • Meets AMS-DTL-23053/4 Class 3 requirements
  • UL 224 VW-1 and CSA OFT recognized
  • Key Temperatures: Shrinks at 90°C, operating temperature of -55°C to + 110°C, maximum use temperature 135°C

Note: Sold in 1 foot sections. Due to the adhesive lining it is pre-cut by the manufacturer in a maximum of 4 foot sections. Example: 12 feet of this heat shrink tubing would be sent as 3 sticks of 4 foot tubing.


Part Number
Size
Ordering Information

Nominal

Before Shrinking

After shrinking

Length (feet)

HS3A-075

3/4"

0.750"

.250"


4'


Write Your Own Review
You're reviewing:3:1 Dual Wall (Adhesive Lined) Heat Shrink Tubing